![]() |
SERIES DMA COMPACT
ULTRA WIDE POWER BANDWIDTH
UN-MEASURABLE DISTORTION CHARACTERISTICS
HIGH RELIABILITY AND EXCEPTIONAL PERFORMANCE
ADDRESSABLE VOX AND MUTING SYSTEM
INDEPENDENT MOH AND 2ND ZONE OUTPUT
VOX VARIABLE MUTE TIME DELAY FUNCTION
INTELLIGENT INPUT/OUTPUT VERSATILITY
AUTOMATIC LOAD MANAGEMENT SYSTEM
POWER SURGE AND OVERLOAD PROTECTION
DMA2015 YDI Price $149.00
DMA2030 YDI Price $199.00
DMA2060 YDI Price $299.00
DMA2120 YDI Price $329.00
DMA3060 YDI Price $319.00
DMA3120 YDI Price $429.00
|
Features
Inputs - Input 1 is set as Microphone Input. Impedance is 250 ohm electronically balanced. This Input may be Transformer balanced by using the optional Transformer Model MT250.
Input 2 is Phone Paging to interface with a Phone System. Input Impedance is 600 ohm, Transformer Balanced. A level control is available on the Front Panel.
Input 3 and 4 can be set at either MIC or AUX Level, (internal Switch/Jumper). Impedance is 250 ohm on MIC and 47 K on AUX.
Phantom Power - Provided on all Inputs set as MIC.
Stereo Summing - Two separate RCA Jacks are provided for Input 3 and 4 (Left and Right). A Stereo signal connected to either Input is buffered and internally summed to Mono.
Input 3 & 4 Attenuators - When the Inputs are set as AUX 1 and AUX 2 the input sensitivity may be varied by a rear panel Variable Attenuator. This feature allows to set the output level of Programs originating from different sources (CD, Satellite Receiver, etc.).
MIX BUSS - This Input/Output may be utilized to parallel two amplifiers or as an input for a Microphone Mixer or other audio source. When used as an Input the Amplifier Level and Equalization Controls have no effect.
Line Out - 600 ohm, 1.5 Volt Line Output.
Remote Volume Control - The INPUT 3/AUX 1 Input Volume may be adjusted from a remote location. Remote Volume Inputs utilize a 10K Pot and are immune to Audio Interference (DC Operation).
Addressable VOX System - The VOX System can be individually selected to operate independently on all 4 Inputs by means of jumpers .
Addressable Muting System - All Inputs may be set to be Muted when the Vox is activated.
Direct Muting/Unmuting System - The MUTE function may be activated by external contacts. MIC 1 Input may be set to normally off and turned-on by shorting the Unmute Terminals.
MUTE Adjustable Delay - A rear panel control adjusts the MUTE Time Delay from 3 Sec. to 60 Sec. Particularly useful to control the length of time that an Input mutes another (for example AUX 1 over AUX 2).
Music on Hold - Output Channel 1 - Channel 1 provides a 1 Volt, 600 ohm Transformer Balanced Output. Internal Jumper selects the source from either AUX 1 or AUX 2. Level Control is provided.
Output Channel 2 - Channel 2 provides a 2 Watt Max., 8 ohm output for Zone 2 Speaker Output. Internal Jumper selects the source from either AUX 1 or AUX 2. Level Control is provided.
Internal Chime Card - An optional Chime Card Model AC1B/DMS is available. When the Direct Muting is activated the Chime is turned-on.
EQ LINK - EQ Link (Preamp. Out) (Power Amp In) jacks are provided for External Equalizer. Activated by the EQ Link Switch.
Tone By-Pass Switch - The Tone by-pass switch defeats the setting of the Treble and Bass Controls. Should be used when an External Equalizer is utilized.
24 VDC Supply Output - A 24 Volt DC, 250 mA regulated Power Supply with dynamic filter is provided for external accessories
|
|
Specifications
Distortion: 0.01% THD at 1 kHz rated power
Frequency Response: 20 hz - 30 Khz ± 2 dB
Inputs:
Input 1 MIC Electronically Balanced, Transformer Balanced with MT250 (optional)
Input 2 Telephone Transformer Balanced
Input 3 MIC Electronically Balanced - AUX 1 (Stereo Summing)
Input 4 MIC Electronically Balanced - AUX 2 (Stereo Summing)
Sensitivity & Z:
Input 1 Mic 1 = 1.5 Mv - 250 ohm
Input 2 Tel=100 Mv - 600 ohm - Transformer Balanced
Input 3 Mic 3 = 1.5 Mv - 250 ohm - AUX 1 = 100 Mv - 47K ohm
Input 4 Mic 4 = 1.5 Mv - 250 ohm - AUX 2 = 100 Mv - 47K ohm
Input Attenuator: AUX 1 and AUX 2
Phantom Power: All Microphone Inputs by internal jumper (18 V)
Hum & Noise: Mic-70 db, Aux-75 db 600 ohm Transformer balanced
Telephone Paging Input:
EQ LINK: Preamp. out, Power Amp in with EQ Link Switch
Line Outputs: Line Out 600 ohm - 1.5 V loaded
Inputs/Outputs: MIX BUSS
Music on Hold Output: 600 ohm-1 Volt Transformer Balanced
Zone 2 Output: 2 Watt Max. - 8 ohm with Control
Main Output Impedance: 8 ohm, 25 Volt and 70 Volt line
Controls:
Front Panel: Input 1 Volume, Input 2 Volume, Input 3 Volume,
Input 4 Volume, Bass and Treble
Rear Panel: AUX 1 Attenuator - AUX 2 Attenuator, VOX Sensitivity
- MOH/ZONE 1 Level Control - ZONE 2 Level Control
- VOX Sensitivity - MUTE Delay
Tone Controls: Bass and Treble ± 10 dB at 100 hZ and 10 KHz
Tone By-Pass: On - Off Switch Rear Panel
Remote Volume Control: INPUT 3 - AUX 1 Input Volume
MOH Source Selection: AUX 1 and AUX 2
Zone 2 Source Selection: AUX 1 and AUX 2
VOX BUSS: Available on all Inputs by internal Jumper
MUTE BUSS: Available on all Inputs by internal Jumper
MUTE DELAY: Adjustable from 3 Sec to 60 Sec (rear panel control)
Direct Muting: External Contact Closure
Unmuting: MUTES/UNMUTES MIC 1 only
Power Supply Output: 24 V DC - 250 mA Regulated
Rack Mounting: Optional 19” Rack Kit
Internal Cooling Fan: Thermally Controlled - Models DMA2060, DMA2120
Protection: Power Surge, Overload and Thermal Protection
Power Requirement: 117 Volt, 50-60 hZ
Power Consumption: DMA2015 = AC = 570 VA - DMA2030 = 600 VA
DMA2060 = 670VA - DMA2120 = 850VA Max.
AC Accessory Outlet: 117 v - 500 W Max. Unswitched
Terminations: Screw Terminals, RCA Jacks
Housing Finish: Black
Output Power Indicator: Multi-color LED Signal and Clip
Dimensions: 10.75”W., 11” D., 4” H. with feet (274X280X102 mm)
3.5” H (89 mm). less feet
Net Weight: DMA2015 = 9.8 Lbs (4.5 Kg)- DMA2030 = 11.75 Lbs (5.4 Kg)
DMA2060 = 12.5 Lbs (5.7 Kg)- DMA2120 = 14.25 Lbs (6.5 Kg)
Specifications are subject to change without notice
|
|
Many other Brands & Types of Public Address Products
& Accessories Are Available!
Bring your Friends & Family to Visit America's Unique Electronic Store.
Prices current 9/29/2008. Prices are subject to change without notice. The products shown above are typically stocked by "You-do-it" Electronics Center. We try to maintain a current listing of current products. Occasionally products which are out of production may be listed on our website. Please E-mail Sales@youdoitelectronics.com or Call for current availability. Prices are subject to change without notice. All orders are subject to acceptance by this company & our Vendor in accordance with its standard acknowledgement form. All prices are subject to all applicable State and/or Local sales taxes. Terms are MasterCard, Visa, Discover, or American Express or Check with order, unless other arrangements are made with our credit department.
To return to the previous page please use your Browser's back button.
|
|