Video, Power Balun with 1 x Transmitter and 1 x Receiver that allows the transmission of real - time CCTV HD power, video signal via cost - effective Unshielded Twisted Paired (UTP) cable. Baseband (composite) signals of any type are supported. The 95-1053 is compatible with all HD - TVI, HD - CVI and AHD analog cameras. Used in pairs, the 95-1053 eliminates costly and bulky coaxial cable. The superior interference rejection and low emissions of the 95-1053 allow video signals to coexist in the same wire bundle as telephone, datacom, or low - voltage power circuits, providing access to shared or pre-existing cables. The 95-1053 has a built - in surge suppressor to protect video equipment against damaging voltage spikes. The built-in circuitry provides against crosstalk and noise immunity to ensure the highest quality video signals.

Specifications:

• UTP Termination: RJ45 Jack (8 Pin)
• Cables:
  (Transmitter) Male BNC Plug and 2.1mm Coax Power Plug pigtail, length 5.9"
  (Receiver) Male BNC Plug and 2.1mm Coax Power Jack pigtail, length 5.9"
• Video Termination: 75 Ohm Male BNC connector
• Video Formats: HD-TVI, HD-CVI, AHD-Analog Signals
• Video Standards: NTSC, PAL & SECAM
• Signal Isolation: 60db Crosstalk and noise immunity
• RJ45 Jack L.E.D.'s: Green L.E.D.=Power, Yellow L.E.D. is not used
• Power: 12-24Vdc
• Lightning Protection: Design Grade III
• Built-in TVS: (Transient Voltage Suppressor) for electrical surge protection
• Housing: ABS Plastic
• Size:Balun Body, L-2.37” x W-1.14” x H-.8”