3D Printing

If you like to tinker and want to explore the exciting world of 3D printing consider 3D Printer Kits from “You-Do-It” Electronics Center. Learn the ins-and-outs of 3D printing by building your own 3D printer from a 3D printer kit. Once assembled use your 3D printer to explore to possibilities of building 3D models before deciding if you want to invest in a fully-assembled machine. Discover why 3D printer kits are the best way to jump into 3D printing – providing you are willing to tinker with your machine. Questions – ask the expert staff at “You-Do-It” Electronics Center.
Items 1 to 10 of 58 total

Grid List

3M Polyimide Film Tape Heat Resistant 1/2" x 36yd, 1205

$24.90
.5 inch width X 36 yard roll Designed for high heat applications Tough and thin Solvent-resistant 

VELLEMAN NTC Thermistor (Version 2) for K8200 3D Printer, NTC104LAF/SP

$7.00
The spare part, NTC104LAF/SP is a 100k NTC Thermistor for the second generation hot end on the K8200 3D Printer Fits through a hole in the heater block for better temperature control of the extruder’s hot end The thermistor provides feedback to the controller for temperature control

VELLEMAN Linear Bearing 10mm for K8200 3D Printer, LM10UU/SP

$3.20
These bearings provide free motion for the K8200 3D Printer linearly, or in one direction Linear bearings do not require any lubrication or maintenance, but keep a few stashed away just in case

MG Chemicals Polymide Tape, POL200-15

$29.95
20cm x 15m (8in x 49ft) 2 mils thick Silicone adhesive Very high heat resistant Superior tensile strength Eases release of heated objects Protects printer bed RoHS and REACH compliant

POLOLU A4988 Stepper Motor Driver, A4988/SP

$7.45
Replacement stepper motor driver card for Velleman K8200 3D Printer  Controls the MOTS4/SP Stepper Motors of the K8200 3D Printer Can be used with a wide variety of stepper motors Simple step and direction control interface Five different step resolutions: full-step, half-step, quarter-step, eighth-step, and sixteenth-step Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay) Over-temperature thermal shutdown, under-voltage lockout, and crossover-current protection Short-to-ground and shorted-load protection

MG CHEMICALS Acetone 945ml, 434-1L

$11.95
Enhances Adhesion to the Print Bed for 3D Printing Smooth Finishing of 3D Printed Pieces Highly Miscible with Other Common Organic Solvents Fast Evaporation Rate VOC Exempt

MG CHEMICALS D-Limonene Pure Grade 945ml, 433-1L

$31.95
ATTENTION! FOR INDUSTRIAL OR LABORATORY USE ONLY NOT FOR RETAIL SALE IN CALIFORNIA, UTAH, AND NEW HAMPSHIRE.