Wire Tracing

13 Item(s)

Grid List

TRIPLETT Fox & Hound Jr Cable Tracing Kit, 3375

$62.79
Hound Jr Pocket-Sized with Pocket Clip Small and Streamlined to get into tight places Adjustable Sensitivity / Volume Control Visual Signal Strength Indicator Contains Hi-Gain Hi-Impedance Amplifier Non-Conductive Probe Tip Detects FOX Jr. Signal from up to 12' away Earphone Jack Power Beeper Reminder Powered by one A23 Battery (included) Fox Jr Pocket-Sized with Pocket Clip Overload Warning Beeper alerts user to potential hazards Connects easily with alligator clips or RJ-11 / RJ-45 combo plug Distinctive Warble tone is adjustable over wide range 120VAC Line Cross Resistant Powered by one A23 Battery (included)  

TRIPLETT Fox & Hound, 3399

$109.99
Hound 3 Adjustable sensitivity and loudness control Bandpass Filter suppresses 60Hz and high frequency noise Identifies Fox 2’s tracer tone up to 12 inches away Headlights illuminate dark areas and reduce fluorescent light noise Built-in signal strength indicator Earphone jack for use in quiet or noisy environments Easy access battery door Rugged, moisture resistant. Mylar cone speaker Fox 2 3 methods of connectivity: RJ-11, RJ-45, or Alligator Clips Cordless phone interface High output, Warble/Pulse selectable Tracer tone Convenient magnetic back for easy mounting TrueTrace cadence shift for definite ID of cable or par within cable Red/Green telephone lines polarity LEDs Tone/Battery LED – indicates that Tracer tone is on and battery status Overload protection to 120 VAC

PLATINUM Tone and Probe Set, TP150

$27.90
Probe Features: Recessed push-button activates tone scanning when needed Tapered tip allows easy penetration of cable bundles Side thumb wheel adjusts volume and turns off power to reserve battery power Probe Sensitivity: 100Hz~300KHz Tone Generator Features: Slide switch to select TONE/OFF/CONT Continuity mode to verify if a wire is broken Alligator clips to test pairs and an RJ11 connector for data or phone lines Tone Generator Output: 1.5KHz square waveform

TRIPLETT Wire Tracer Kit, CTX30

$24.99
Quickly trace wires and check phone lines Adjustable sensitivity Audible and visual notification Tip/Ring/Continuity testing

KLEIN Electrical Test Kit, 69149

$39.94
The MM300 multimeter measures AC/DC voltage, DC current and resistance and has a safety rating of CAT III 600V, Class 2, Double insulation The NCVT-1 has a bright green LED to indicate the tester is working; it changes to red and warning tones sound when voltage is detected NCVT-1 has a digitally-controlled ON/OFF power button and auto power-off feature to conserve and extend battery life Receptacle tester detects wiring configurations and indicates correct wiring, and identifies common wiring faults Identifies open ground, open hot, open neutral, hot/ground reversed; it does not indicate quality of ground, multiple hot wires, or a combination of defects MM300 tests continuity with visual and audible continuity indicators Test leads included for MM300; batteries included for NCVT-1 and MM300

KLEIN WiFi Borescope, ET20

$84.97
WiFi Borescope transmits and displays video and images directly to your smartphone up to 30 Feet (9 m) away Waterproof 9 mm camera has 6 on-board, adjustable LED lights and outputs high-quality 640 x 480 images Tough, armored 6-Foot (1.8 m) long waterproof camera gooseneck maneuvers around obstacles while maintaining rigidity Battery status indicator tracks the charge level of the lithium-ion battery Increase and decrease camera LED output either on the Borescope or in the App The App not only acts as a display, but stores and shares images and videos via text or email Includes convenient pocket clip, USB charging cable, hook attachment, carrying case, and instructions The Klein Borescope App is available free at the App Store® for iPhone® users and Google Play® for Android® users

KLEIN AC/DC Digital Clamp Meter, 400A Auto-Ranging, CL380

$89.99
Measures both AC/DC current via the clamp Non-contact voltage tester integrated into the clamp jaw High-visibility reverse contrast LCD display for improved viewability in all ambient lighting conditions Automatically ranging True Root Mean Squared (TRMS) measurement technology for accuracy Measures AC/DC voltage, DC micro-Amp current, resistance, continuity, frequency, duty-cycle, capacitance and tests diodes via the test leads Measures temperature with a K-Type thermocouple probe Max/min, Rel/zero and data hold capability Auto power off after five minutes to conserve battery life Low battery indicator and easily accessible battery compartment Built to withstand a 6.6 foot (2m) drop Includes a carrying case, test leads, thermocouple probe, instruction manual and 3 x AAA batteries CAT III 600V, Class 2, Double insulation safety rating Meets requirements for use in basic and controlled electromagnetic environments like residential, office and light-industrial locations

KLEIN Digital Circuit Breaker Finder with GFCI Outlet Tester, ET310

$49.99
Quickly and accurately locate the correct circuit breaker in a panel corresponding to the circuit to which an electrical outlet or fixture is connected Tester consists of two parts: a Transmitter, connected to the electrical outlet or fixture and a Receiver, used to scan the panel to locate the correct breaker Receiver delivers clear visual and audible indications when the correct breaker has been located Operates on 90-120V AC circuits Transmitter incorporates a GFCI outlet tester to inspect the wiring condition at the electrical outlet and test GFCI devices Transmitter docks in the Receiver for convenient storage as a single item when tester is not is use Transmitter incorporates a three-pin plug for connecting to North-American-style grounded electrical outlets. The transmitter may be connected to other electrical fixtures using optional accessories which are sold separately (Cat. No. 69411) Receiver powers off automatically after approximately three minutes of non-use to conserve battery life Transmitter is powered by the circuit when connected to the electrical outlet or fixture Low battery indicator Easily accessible battery compartment. Uses one 9V battery in receiver only; Transmitter does not require a battery Built to withstand a 6.6-Foot (2 m) drop CAT II 120V safety rating Measurement Category II is applicable to test and measuring circuits connected directly to utilization points (socket outlets and similar points) of the low-voltage MAINS installation Includes Transmitter, Receiver, user manual, and 9V battery (for Receiver)

KLEIN Tone & Probe PRO Kit, VDV500-820

$79.90
Includes a professional grade tone generator and tracing probe for non-active wiring Toner-Pro features 5 distinct tone cadences Rugged Angled Bed of Nails (ABN) clips securely attach to wires RJ11 plug easily connects to telephone and RJ45 data jacks to tone wire pair Toner-Pro tests for continuity and polarity with results indicated by clearly labeled LEDs Probe-Pro features 3.5 mm headphone jack for noisy environments (headphones not included) Responsive probe with durable non-metallic, replaceable conductive tip (VDV999-068) - sold separately Work light on probe tip for use in dark spaces Terminal block on probe to confirm the toned pair Each tool includes 4X AAA batteries Custom, padded, divided, zipper pouch for convenient storage (VDV770-500) included with kit

KLEIN Probe-PRO Tracing Probe, VDV500-123

$39.99
Traces non-energized wiring when used with Toner-Pro Tone Generator (VDV500-063, sold separately) Responsive, durable, replaceable non-metallic, conductive tip Work light for use in dark spaces 3.5 mm headphone jack for noisy environments (headphones not included) Terminal block on probe to confirm the toned pair has been located Tool-less, twist-and-lock replacement tip (VDV999-068) available One push power button with power-on LED indicator - no need to hold button down Auto power-off Low battery indicator 4 x AAA batteries included Includes a loop for a lanyard Works with Klein's Scout Pro, Lan Scout, Jr. and Commander series of testers

KLEIN Toner-PRO Tone Generator, VDV500-063

$49.99
Professional grade tone generator for non-active wiring For use with Probe-Pro Tracing Probe (VDV500-123) required (sold separately) Five distinct tone cadences Rugged Angled Bed of Nails (ABN) clips securely attach to wires RJ11 plug easily connects to telephone or RJ45 data jacks to tone individual conductors or wire pairs Tests for continuity and polarity with response displayed on clearly labeled, easy-to-read LEDs Auto Power-Off and Low Battery Indicator Loop for a lanyard (4) AAA Batteries included

KLEIN Dual Range Non-Contact Voltage Tester with Laser Pointer, NCVT-5A

$24.97
Voltage Tester provides non-contact determination of AC voltage in cables, cords, circuit breakers, switches, outlets and wires, as well as AC voltage in security, entertainment, communications, environmental control and irrigation systems Dual-range testing: select 12 to 1000V AC which is perfect for low voltage systems such as doorbells, environmental control or irrigation systems, or select 70 to 1000V AC which is perfect for detecting systems such as electrical mains supply Bright integrated laser pointer for identifying objects of interest at distance on the jobsite Simple to use intuitive interface is easy to change between voltage detection ranges and easy to determine the currently active range Delivers simultaneous visual and audible voltage indicators when AC voltage is detected Audible voltage indicator beeps at a greater frequency the higher the voltage that is sensed, or the closer to the voltage source Built to withstand a 9.9-Foot / 3-meter drop ''Auto Power-Off'' conserves battery life Screw-thread battery cap Lightweight, compact tool with pocket clip provides convenient storage and quick access CAT IV 1000V safety rating