Servo

5 Item(s)

Grid List

HITEC HSR-1425CR Servo Continuous Rotation, HSR-1425CR

$16.99
The HSR-1425CR is the continuous rotation version of the HS-425HB The speed is proportional meaning that the further the PWM signal deviates from the idle signal (approximately 1500usec) the faster the servo will rotate If you're looking for the smoothest continuous rotation servo, be sure to check out the HSR-2645CR servo

HITEC HSR-2645CR Servo Continuous Rotation, HSR-2645CR

$31.99
While regular servos that get modified to continuous rotation tend to be difficult to control the speed on, the HSR-2645CR circuit was designed from the factory to drive the servo smoothly and with fine-control over the speed Since the HSR-2645CR servo is digital, it's able to be tuned using a Hitec servo programmer The programmable parameters allow you to tailor the servo to best-fit your application Excellent for compact sliders, winch mechanisms, small panning devices and wheel-drives on robots

OSEPP Motor Encoder (set of 2), ENC-01

$24.15
4.5 – 24 Volt operation 11 pole encoder Two solid state 3144 Hall effect sensors 100% Arduino compatible Designed for 25mm DC motors Package Content 2 x Motor Encoders 2 x Metal mounts (for 25mm motors) 2 x Magnets

OSEPP Standard Economy Servo Motor, LS-5010SR

$9.89
Voltage Range:  4.8 – 7.2 Volts Stall Torque (6.0V): 4.1 kg.cm Stall Torque (4.8V): 3.2kg.cm JR Wire Configuration No-load Speed (6.0V / 4.8V):  0.19sec/60° / 0.23sec/60° Dimensions: 40.8*20.1*38mm Weight: 44g Rotation: 180 degrees Output Shaft Style: 25 tooth spline

OSEPP Standard Economy Servo Motor Contiuous Rotation, LS-5010CR

$19.95
Suitable for hobby, models, science and other projects. Comparable to Servocity # 31311S20 Voltage Range:  4.8 – 7.2 Volts Stall Torque (6.0V): 4.1 kg.cm Stall Torque (4.8V): 3.2kg.cm JR Wire Configuration No-load Speed (6.0V / 4.8V):  0.19sec/60° / 0.23sec/60° Dimensions: 40.8*20.1*38mm Weight: 44g Rotation: Continuous Output Shaft Style: 25 tooth spline