Because our price on this item is lower than the manufacturer's
suggested retail price , the manufacturer does not allow us to show
you our price until you place the item in your shopping cart.
Adding this item won't require you to purchase the product. You
can easily remove the product from your cart if you decide not to buy it.
Input Impedance: XLR: 600 Ohms, 1/8" (3.5mm): 10K Ohms
Output Impedance: 600 Ohms
Frequency Response: 35 Hz - 20 kHz
Max Level: +26 dBm
Dimensions: 3" x 2.25" x 1.2"
Splits balanced XLR input, or 1/8" input to two balanced XLR
Combines two balanced XLR signals to one XLR output. NOTE: Will only pass phantom power to one microphone.
One signal is transformer isolated from the other.
Ground Lift switch for noise elimination
Frequency response: 20Hz to 70 kHz +/- .5dB
Distortion: < 0.005% THD @ 1 khz
Crosstalk: > -97 dB
Max source impedance: 1 K Ohm
Min load impedance: 10 K Ohm
Eliminates ground loop hum and buzz.
Leaves signal grounds connected.
Passive, the unit requires no power.
Converts balanced lines to unbalanced lines and vice-versa.
Adjusts signal voltages to match difference in ground potential.
4: 1/4" TRS Headphone Outputs with Level Control.
With the new JRC3414 I.C.'s it has plenty of gain!!!
1/4" , 3.5mm and RCA A and B Inputs.
Switchable mono or stereo for both A and B inputs
Input Impedance: 10 K Ohms
Maximum Input Level: +26 dBV
Max Gain: 20 dB per channel
Output Power: 326 mW per side, 652 mW per channel (@ 62 Ohms)
S/N Ratio: 92 dB
Power: 15 VDC (Adapter included)
Size: 6.75 x 1.75 x 4.75"
Mixes one XLR microphone and a source signal to a single XLR microphone level output
Passive unit does not require a power source so it can be used anywhere
Switchable mixing for quick operation
Single source level control for proper attenuation of the source inputs
Splits Stereo RCA and stereo 1/8" (3.5mm) signals
Individual Right and Left level controls
Transformer balanced XLR mono output.
Hum elimination/ground lift switch
Max Input Level: +20 dB
Max Output Level: +20dB RCA, 0 dB XLR
Frequency Response: (Low Z) 50 Hz to 16 kHz
Expands the output of a stereo device to multiple outputs
Can raise the output level to true line level for any output
Stereo 4 channel distribution amplifier
Front panel volume controls
Mono or Stereo operation
DC low end frequency for audiophile frequency response
Small compact design
Accepts inputs directly from I-pad / I-pod or laptop
Included Rolls PS27s power supply.
Stereo pass thru: For connection to another DA134
Professional bluetooth audio adapter
Stereo RCA and 1/8” Outputs
Mono XLR mic level output
Powder coated steel chassis
Max Trans. distance 20M/60FT (line of sight to front)
Format support WAV/WMA/FLAC/APE/MP3 lossless stereo output
Bluetooth Version 4.2